> 15 mCoul/gm carbon: helium carrier, 0.018-in. Stray light - 18 mCoul/gm carbon: nitrogen carrier, 0.018-in.EP resolution test - >1.6 toluene in hexane, ratio abs.Specifications 8453 UV-Visible Spectrophotometer:
#Shimadzu multispec 1501 schematic software#
The instrument is controlled via the GRAMS/AI software which allows for standard data processing such as baseline correction (multi-point, polynomial fit), Peak fitting (Gaussian, Lorentzian, Voigt and other functions), Smoothing, Derivatives, Automatic spectral subtraction, and Spectral unit conversion. The wavelength range is from 7,800 to 350 cm-1. The sample compartment is accessible from front side. All models are step selectable down to 32cm-1.
#Shimadzu multispec 1501 schematic full#
The spectrometer provides a full range of resolution, from 2cm-1 for routine analysis up to 0.5cm-1 for high resolution work such as gas analysis. MIDAC FT/IR Spectrometer (located in room 152) (1 scan accumulation, 4 cm-1 spectral resolution, measured peak maxima deviation from peak position 3060.02 cm-1).Wavelength accuracy Better than 0.1 cm-1 at 1,600 cm-1.(4 cm-1 spectral resolution, 5 second data collection time, room temperature, KBr optics, DTGS detector).Wavelength range 7,800-350 cm-1 Optimized KBr beamsplitter.The FT-IR spectrophotometer is controlled by Spectrum One HP software, which allows the user obtain qualitative and quantitative data from the method and generate custom reports. FTIR Spectrometer is capable of data collection over a wavenumber range of 370-7800 cm-1 using a fast recovery deuterated triglycine sulfate detector with KBr splitting. It is configured to run in single-beam, ratio, or interferogram modes. The FT-IR spectrophotometer is equipped with both transmission and ATR modes. PerkinElmer Spectrum One FT-IR Spectrophotometer (located in room 152) The Eclipse's performance can be validated using the built-in instrument test software.A phosphorescence data point is captured every microsecond.Detector collects 80 points/second and gets all the steady-state fluorescence kinetic data.Collection mode can be fluorescence, phosphorescence or chemi/bio luminescence.The Cary Eclipse is controlled by the Cary Eclipse Bio Pack software.įeatures of the Cary Eclipse Fluorimeter include: The Cary Eclipse fluorescence spectrophotometer uses xenon flash lamp technology, plug-and-identify electronics and featured-packed, intuitive software. The Cary Eclipse is equipped with both standard single cell base holder and microplate reader accessory.
Facilities and Equipment:Ĭary Eclipse Fluorescence Spectrophotometer (located in room 152) The lab manager, Jose Calderon, provides training and assistance in the use of the facility equipment. The facility provides the Chemistry Department with modern instruments for the chemical analyses using the following techniques: Gas chromatography (FID and TCD detectors), Gas Chromatography-Mass Spectroscopy, HPLC, Fourier Transform Infrared Spectroscopy, UV-Visible Spectroscopy, Fluorescence Spectroscopy, and both Flame and Graphite Furnace Atomic Absorption Spectroscopy. Jose Calderon Services provided by the Departmental Instrumentation Lab: Hours of operation are from 8:00 AM till 5:00 PM.ĭirector: Dr. UNT Department of Chemistry - Instrumentation Lab The Chemistry Departmental Instrumentation Laboratory is located in Room 152 Chemistry Building.
0 kommentar(er)
